A more specialized noodle machine manufacturer - Ushering in a new era of turnkey projects
Customer Service
How to deal with common faults of fresh noodle machine
Using a fresh pasta machine can sometimes cause minor problems such as panels that fail to connect, resulting in analysis of broken or mutilated panels. This situation is usually caused by the gap between the rolls. When the panel breaks, the gap between the lower pair of rolls can be reduced, or the gap between the upper pair of rolls can be increased, and the residual panel can be adjusted in the opposite way to the broken panel.
The uneven thickness of the running side or both sides is caused by the inconsistent gap between the two ends of the rolls, which can be solved by properly adjusting the gap between the two ends of the rolls. The noodle is curved, which is caused by the scraper and knife comb installation angle is too large, and can be solved by proper adjustment. The roller sticking to the panel is usually caused by too much moisture in the panel blank, and another factor is a loose scraper bolt.
The noodles do not break during processing, mainly because the cutting edge of the cross section is not consistent with the bottom plate, which can be solved by adjusting the position properly. The reason why the noodles are broken is because there are impurities in the noodles, which may also be caused by the unevenness of the noodles.
Operation steps:The fresh noodle machine is an automatic noodle production equipment, which can produce wide noodles, round noodles, hanging noodles, etc. The noodle pressing operation is simple and fast, but it is also important to remember the operation rules of the noodle machine when it is convenient to use. When operating the fresh noodle machine, wear sleeves and work cap, and tuck your long hair into the cap. When the machine is running, keep your fingers away from the drum and do not use your hands to send and press the noodles. It is strictly forbidden to touch the exposed transmission parts with your hands to avoid accidents.
If the fresh noodle machine breaks down during use, it should be stopped immediately for maintenance and used again after troubleshooting. Cut off the power supply after use and do not wash the charged equipment with water to avoid damaging the machine. The noodle machine is very easy to use, and it is very convenient to change the noodle cutter. Just put the noodle cutter into the groove, after the gear of the noodle cutter engages with the big gear, tighten the nut and fix the noodle cutter with the fixed bracket.
Contact person: Tracy Shen
Contact number: +86-15664100838
Address: Xingyang, Zhengzhou, Henan, China